Furnace Repair Services in Spring Green, WI

The draft inducer is a small motorized fan that turns on before the burners ignite. Its purpose is to pull combustion air through the heat exchanger and expel toxic exhaust gases safely out the flue vent. A pressure switch verifies that this draft is established; if the inducer motor fails or the vent is blocked, the furnace will lock out as a safety precaution.

Cold air discharge usually points to an extinguished pilot flame, an oxidized flame sensor rod that shuts down the gas valve after a few seconds, an overheated heat exchanger tripping the high-limit switch, or an ignition lock-out. Our certified technicians in Spring Green, Wisconsin utilize digital multimeters and combustion testers to pinpoint the exact failure point and restore comfortable heat.

As an industry rule of thumb, if your furnace is under 12 years old and the estimated repair expense is less than 50% of the cost of a replacement system, professional repair is generally the most economical choice. However, if your unit has a compromised heat exchanger or requires chronic seasonal fixes, our Spring Green, Wisconsin team will provide an unbiased, pressure-free evaluation of your options.

Our factory-trained technicians carry diagnostic tools and OEM-certified parts for all major brands, including Carrier, Trane, Lennox, Rheem, Goodman, York, Bryant, Heil, Ruud, Amana, and Day & Night. Whether your unit is a high-efficiency 96% AFUE condensing model or a standard 80% atmospheric system, we have you covered in Spring Green, Wisconsin.

A fractured heat exchanger is a critical safety issue that can contaminate household air with carbon monoxide. Key warning signs include persistent soot streaks around the burner doors, a pungent chemical smell resembling formaldehyde, burner flames that flicker or burn yellow rather than steady blue, and unexplained headaches among household members. We use fiber-optic inspection cameras in Spring Green, Wisconsin to check internal heat exchanger integrity.

Yes. The flame sensor sits directly in the burner flame and generates a micro-amp electrical current when heated to prove to the control board that fire is present. Over time, silica and carbon coat the metal rod, preventing flame detection and causing the furnace to shut off its gas valve after 3 to 5 seconds. Cleaning or replacing this sensor is a routine, fast repair for our Spring Green, Wisconsin specialists.