Furnace Repair Services in Graham, WA

Yes. The flame sensor sits directly in the burner flame and generates a micro-amp electrical current when heated to prove to the control board that fire is present. Over time, silica and carbon coat the metal rod, preventing flame detection and causing the furnace to shut off its gas valve after 3 to 5 seconds. Cleaning or replacing this sensor is a routine, fast repair for our Graham, Washington specialists.

Yes. Modern thermostats communicate low-voltage signals (24VAC) to the furnace control board. Dead internal batteries, damaged wiring, loose C-wire connections, or faulty internal relays will prevent your furnace from receiving the heating call. Our technicians in Graham, Washington test control circuit voltages and can re-wire or recalibrate your thermostat during the service call.

The draft inducer is a small motorized fan that turns on before the burners ignite. Its purpose is to pull combustion air through the heat exchanger and expel toxic exhaust gases safely out the flue vent. A pressure switch verifies that this draft is established; if the inducer motor fails or the vent is blocked, the furnace will lock out as a safety precaution.

A fractured heat exchanger is a critical safety issue that can contaminate household air with carbon monoxide. Key warning signs include persistent soot streaks around the burner doors, a pungent chemical smell resembling formaldehyde, burner flames that flicker or burn yellow rather than steady blue, and unexplained headaches among household members. We use fiber-optic inspection cameras in Graham, Washington to check internal heat exchanger integrity.

A loud bang upon ignition indicates delayed ignition. When burner orifices become partially obstructed with dust, rust, or spiderwebs, gas collects inside the combustion chamber before reaching the ignition source, creating a mini-explosion when it finally catches. This can warp or crack heat exchangers over time. Contact (877) 719-1221 immediately in Graham, Washington to have the burners professionally serviced.

During warm summer months, ambient dust settles onto the furnace burners and heat exchanger surfaces. During the first cold snap, this thin layer of dust burns off, producing a mild, transient burning odor that typically disappears within 30 to 45 minutes. If the smell persists, smells of burning plastic/wiring, or produces visible smoke, shut down the system and call (877) 719-1221 immediately.