Furnace Repair Services in Herriman, UT

Electric furnaces do not use combustible fuel or heat exchangers; instead, they pass high-voltage electric current through heavy-duty nichrome heating elements. Common electric furnace repairs involve replacing broken heating coils, stuck electric sequencers, faulty contactors, or blown thermal fuses. Our technicians in Herriman, Utah service both electric and gas heating configurations.

HVAC manufacturers and safety organizations recommend scheduling professional maintenance once per year, ideally in early autumn prior to continuous winter operation. Annual tune-ups clean combustion residues, verify gas pressure, inspect electrical connections, and verify safety controls, which prevents mid-winter breakdowns and lowers monthly utility bills in Herriman, Utah.

Yes, Local Furnace Repair Pro backs every heating repair with a comprehensive warranty on all installed replacement parts and labor. If the repaired component experiences any performance issues during the warranty period, we will send a technician back to your Herriman, Utah home to rectify the issue without delay.

First, verify that your thermostat is set to "Heat" mode with the setpoint at least 5 degrees above current room temperature. Check that the emergency power switch mounted on or near your furnace is in the "On" position, and inspect your home electrical panel for a tripped heating breaker. If the blower runs but only delivers chilly air, or if you hear repetitive clicking without ignition, call (877) 719-1221 immediately for fast heating assistance in Herriman, Utah.

The draft inducer is a small motorized fan that turns on before the burners ignite. Its purpose is to pull combustion air through the heat exchanger and expel toxic exhaust gases safely out the flue vent. A pressure switch verifies that this draft is established; if the inducer motor fails or the vent is blocked, the furnace will lock out as a safety precaution.

During warm summer months, ambient dust settles onto the furnace burners and heat exchanger surfaces. During the first cold snap, this thin layer of dust burns off, producing a mild, transient burning odor that typically disappears within 30 to 45 minutes. If the smell persists, smells of burning plastic/wiring, or produces visible smoke, shut down the system and call (877) 719-1221 immediately.