Furnace Repair Services in Cameron Park, TX

Natural gas utilities add mercaptan (a distinctive rotten-egg smell) to help you detect leaks. If you smell gas, evacuate everyone from the house immediately without operating wall switches, phones, or electrical devices that could create an electrical spark. From outside your home in Cameron Park, Texas, contact your local gas utility and call (877) 719-1221 for emergency gas valve and line inspection.

Yes. The flame sensor sits directly in the burner flame and generates a micro-amp electrical current when heated to prove to the control board that fire is present. Over time, silica and carbon coat the metal rod, preventing flame detection and causing the furnace to shut off its gas valve after 3 to 5 seconds. Cleaning or replacing this sensor is a routine, fast repair for our Cameron Park, Texas specialists.

As an industry rule of thumb, if your furnace is under 12 years old and the estimated repair expense is less than 50% of the cost of a replacement system, professional repair is generally the most economical choice. However, if your unit has a compromised heat exchanger or requires chronic seasonal fixes, our Cameron Park, Texas team will provide an unbiased, pressure-free evaluation of your options.

The draft inducer is a small motorized fan that turns on before the burners ignite. Its purpose is to pull combustion air through the heat exchanger and expel toxic exhaust gases safely out the flue vent. A pressure switch verifies that this draft is established; if the inducer motor fails or the vent is blocked, the furnace will lock out as a safety precaution.

During warm summer months, ambient dust settles onto the furnace burners and heat exchanger surfaces. During the first cold snap, this thin layer of dust burns off, producing a mild, transient burning odor that typically disappears within 30 to 45 minutes. If the smell persists, smells of burning plastic/wiring, or produces visible smoke, shut down the system and call (877) 719-1221 immediately.

Cold air discharge usually points to an extinguished pilot flame, an oxidized flame sensor rod that shuts down the gas valve after a few seconds, an overheated heat exchanger tripping the high-limit switch, or an ignition lock-out. Our certified technicians in Cameron Park, Texas utilize digital multimeters and combustion testers to pinpoint the exact failure point and restore comfortable heat.