Furnace Repair Services in Pelham, TN

Yes. Modern thermostats communicate low-voltage signals (24VAC) to the furnace control board. Dead internal batteries, damaged wiring, loose C-wire connections, or faulty internal relays will prevent your furnace from receiving the heating call. Our technicians in Pelham, Tennessee test control circuit voltages and can re-wire or recalibrate your thermostat during the service call.

Yes. The flame sensor sits directly in the burner flame and generates a micro-amp electrical current when heated to prove to the control board that fire is present. Over time, silica and carbon coat the metal rod, preventing flame detection and causing the furnace to shut off its gas valve after 3 to 5 seconds. Cleaning or replacing this sensor is a routine, fast repair for our Pelham, Tennessee specialists.

This symptom is known as short-cycling. The most common culprit is a severely restricted airflow caused by a clogged furnace filter, which traps intense heat inside the cabinet and trips the high-temperature safety switch. Other potential causes include a malfunctioning draft inducer fan, an oversized unit, or a blocked chimney flue exhaust. Our Pelham, Tennessee technicians can calibrate and clear the system safely.

Cold air discharge usually points to an extinguished pilot flame, an oxidized flame sensor rod that shuts down the gas valve after a few seconds, an overheated heat exchanger tripping the high-limit switch, or an ignition lock-out. Our certified technicians in Pelham, Tennessee utilize digital multimeters and combustion testers to pinpoint the exact failure point and restore comfortable heat.

A fractured heat exchanger is a critical safety issue that can contaminate household air with carbon monoxide. Key warning signs include persistent soot streaks around the burner doors, a pungent chemical smell resembling formaldehyde, burner flames that flicker or burn yellow rather than steady blue, and unexplained headaches among household members. We use fiber-optic inspection cameras in Pelham, Tennessee to check internal heat exchanger integrity.

The draft inducer is a small motorized fan that turns on before the burners ignite. Its purpose is to pull combustion air through the heat exchanger and expel toxic exhaust gases safely out the flue vent. A pressure switch verifies that this draft is established; if the inducer motor fails or the vent is blocked, the furnace will lock out as a safety precaution.