Furnace Repair Services in Chain of Rocks, MO

Yes. The flame sensor sits directly in the burner flame and generates a micro-amp electrical current when heated to prove to the control board that fire is present. Over time, silica and carbon coat the metal rod, preventing flame detection and causing the furnace to shut off its gas valve after 3 to 5 seconds. Cleaning or replacing this sensor is a routine, fast repair for our Chain of Rocks, Missouri specialists.

HVAC manufacturers and safety organizations recommend scheduling professional maintenance once per year, ideally in early autumn prior to continuous winter operation. Annual tune-ups clean combustion residues, verify gas pressure, inspect electrical connections, and verify safety controls, which prevents mid-winter breakdowns and lowers monthly utility bills in Chain of Rocks, Missouri.

The draft inducer is a small motorized fan that turns on before the burners ignite. Its purpose is to pull combustion air through the heat exchanger and expel toxic exhaust gases safely out the flue vent. A pressure switch verifies that this draft is established; if the inducer motor fails or the vent is blocked, the furnace will lock out as a safety precaution.

During warm summer months, ambient dust settles onto the furnace burners and heat exchanger surfaces. During the first cold snap, this thin layer of dust burns off, producing a mild, transient burning odor that typically disappears within 30 to 45 minutes. If the smell persists, smells of burning plastic/wiring, or produces visible smoke, shut down the system and call (877) 719-1221 immediately.

This symptom is known as short-cycling. The most common culprit is a severely restricted airflow caused by a clogged furnace filter, which traps intense heat inside the cabinet and trips the high-temperature safety switch. Other potential causes include a malfunctioning draft inducer fan, an oversized unit, or a blocked chimney flue exhaust. Our Chain of Rocks, Missouri technicians can calibrate and clear the system safely.

Yes. Modern thermostats communicate low-voltage signals (24VAC) to the furnace control board. Dead internal batteries, damaged wiring, loose C-wire connections, or faulty internal relays will prevent your furnace from receiving the heating call. Our technicians in Chain of Rocks, Missouri test control circuit voltages and can re-wire or recalibrate your thermostat during the service call.