Furnace Repair Services in Aurora Springs, MO

As an industry rule of thumb, if your furnace is under 12 years old and the estimated repair expense is less than 50% of the cost of a replacement system, professional repair is generally the most economical choice. However, if your unit has a compromised heat exchanger or requires chronic seasonal fixes, our Aurora Springs, Missouri team will provide an unbiased, pressure-free evaluation of your options.

This symptom is known as short-cycling. The most common culprit is a severely restricted airflow caused by a clogged furnace filter, which traps intense heat inside the cabinet and trips the high-temperature safety switch. Other potential causes include a malfunctioning draft inducer fan, an oversized unit, or a blocked chimney flue exhaust. Our Aurora Springs, Missouri technicians can calibrate and clear the system safely.

Electric furnaces do not use combustible fuel or heat exchangers; instead, they pass high-voltage electric current through heavy-duty nichrome heating elements. Common electric furnace repairs involve replacing broken heating coils, stuck electric sequencers, faulty contactors, or blown thermal fuses. Our technicians in Aurora Springs, Missouri service both electric and gas heating configurations.

Yes. The flame sensor sits directly in the burner flame and generates a micro-amp electrical current when heated to prove to the control board that fire is present. Over time, silica and carbon coat the metal rod, preventing flame detection and causing the furnace to shut off its gas valve after 3 to 5 seconds. Cleaning or replacing this sensor is a routine, fast repair for our Aurora Springs, Missouri specialists.

Yes. Modern thermostats communicate low-voltage signals (24VAC) to the furnace control board. Dead internal batteries, damaged wiring, loose C-wire connections, or faulty internal relays will prevent your furnace from receiving the heating call. Our technicians in Aurora Springs, Missouri test control circuit voltages and can re-wire or recalibrate your thermostat during the service call.

The draft inducer is a small motorized fan that turns on before the burners ignite. Its purpose is to pull combustion air through the heat exchanger and expel toxic exhaust gases safely out the flue vent. A pressure switch verifies that this draft is established; if the inducer motor fails or the vent is blocked, the furnace will lock out as a safety precaution.