Furnace Repair Services in Bentonia, MS

Yes. The flame sensor sits directly in the burner flame and generates a micro-amp electrical current when heated to prove to the control board that fire is present. Over time, silica and carbon coat the metal rod, preventing flame detection and causing the furnace to shut off its gas valve after 3 to 5 seconds. Cleaning or replacing this sensor is a routine, fast repair for our Bentonia, Mississippi specialists.

High-pitched screeching or metallic grinding usually signals failing sleeve or ball bearings inside the blower motor, or a misaligned blower wheel scraping against the housing. Operating a furnace with damaged bearings can overheat the motor and burn out internal electrical windings. Our Bentonia, Mississippi technicians can lubricate, re-align, or replace the blower motor assembly promptly.

The draft inducer is a small motorized fan that turns on before the burners ignite. Its purpose is to pull combustion air through the heat exchanger and expel toxic exhaust gases safely out the flue vent. A pressure switch verifies that this draft is established; if the inducer motor fails or the vent is blocked, the furnace will lock out as a safety precaution.

During warm summer months, ambient dust settles onto the furnace burners and heat exchanger surfaces. During the first cold snap, this thin layer of dust burns off, producing a mild, transient burning odor that typically disappears within 30 to 45 minutes. If the smell persists, smells of burning plastic/wiring, or produces visible smoke, shut down the system and call (877) 719-1221 immediately.

A fractured heat exchanger is a critical safety issue that can contaminate household air with carbon monoxide. Key warning signs include persistent soot streaks around the burner doors, a pungent chemical smell resembling formaldehyde, burner flames that flicker or burn yellow rather than steady blue, and unexplained headaches among household members. We use fiber-optic inspection cameras in Bentonia, Mississippi to check internal heat exchanger integrity.

Cold air discharge usually points to an extinguished pilot flame, an oxidized flame sensor rod that shuts down the gas valve after a few seconds, an overheated heat exchanger tripping the high-limit switch, or an ignition lock-out. Our certified technicians in Bentonia, Mississippi utilize digital multimeters and combustion testers to pinpoint the exact failure point and restore comfortable heat.