Furnace Repair Services in Putney, GA

Yes. Modern thermostats communicate low-voltage signals (24VAC) to the furnace control board. Dead internal batteries, damaged wiring, loose C-wire connections, or faulty internal relays will prevent your furnace from receiving the heating call. Our technicians in Putney, Georgia test control circuit voltages and can re-wire or recalibrate your thermostat during the service call.

During warm summer months, ambient dust settles onto the furnace burners and heat exchanger surfaces. During the first cold snap, this thin layer of dust burns off, producing a mild, transient burning odor that typically disappears within 30 to 45 minutes. If the smell persists, smells of burning plastic/wiring, or produces visible smoke, shut down the system and call (877) 719-1221 immediately.

Yes. The flame sensor sits directly in the burner flame and generates a micro-amp electrical current when heated to prove to the control board that fire is present. Over time, silica and carbon coat the metal rod, preventing flame detection and causing the furnace to shut off its gas valve after 3 to 5 seconds. Cleaning or replacing this sensor is a routine, fast repair for our Putney, Georgia specialists.

Electric furnaces do not use combustible fuel or heat exchangers; instead, they pass high-voltage electric current through heavy-duty nichrome heating elements. Common electric furnace repairs involve replacing broken heating coils, stuck electric sequencers, faulty contactors, or blown thermal fuses. Our technicians in Putney, Georgia service both electric and gas heating configurations.

Cold air discharge usually points to an extinguished pilot flame, an oxidized flame sensor rod that shuts down the gas valve after a few seconds, an overheated heat exchanger tripping the high-limit switch, or an ignition lock-out. Our certified technicians in Putney, Georgia utilize digital multimeters and combustion testers to pinpoint the exact failure point and restore comfortable heat.

This symptom is known as short-cycling. The most common culprit is a severely restricted airflow caused by a clogged furnace filter, which traps intense heat inside the cabinet and trips the high-temperature safety switch. Other potential causes include a malfunctioning draft inducer fan, an oversized unit, or a blocked chimney flue exhaust. Our Putney, Georgia technicians can calibrate and clear the system safely.