Furnace Repair Services in Lithonia, GA

Cold air discharge usually points to an extinguished pilot flame, an oxidized flame sensor rod that shuts down the gas valve after a few seconds, an overheated heat exchanger tripping the high-limit switch, or an ignition lock-out. Our certified technicians in Lithonia, Georgia utilize digital multimeters and combustion testers to pinpoint the exact failure point and restore comfortable heat.

Yes. The flame sensor sits directly in the burner flame and generates a micro-amp electrical current when heated to prove to the control board that fire is present. Over time, silica and carbon coat the metal rod, preventing flame detection and causing the furnace to shut off its gas valve after 3 to 5 seconds. Cleaning or replacing this sensor is a routine, fast repair for our Lithonia, Georgia specialists.

High-pitched screeching or metallic grinding usually signals failing sleeve or ball bearings inside the blower motor, or a misaligned blower wheel scraping against the housing. Operating a furnace with damaged bearings can overheat the motor and burn out internal electrical windings. Our Lithonia, Georgia technicians can lubricate, re-align, or replace the blower motor assembly promptly.

A fractured heat exchanger is a critical safety issue that can contaminate household air with carbon monoxide. Key warning signs include persistent soot streaks around the burner doors, a pungent chemical smell resembling formaldehyde, burner flames that flicker or burn yellow rather than steady blue, and unexplained headaches among household members. We use fiber-optic inspection cameras in Lithonia, Georgia to check internal heat exchanger integrity.

This symptom is known as short-cycling. The most common culprit is a severely restricted airflow caused by a clogged furnace filter, which traps intense heat inside the cabinet and trips the high-temperature safety switch. Other potential causes include a malfunctioning draft inducer fan, an oversized unit, or a blocked chimney flue exhaust. Our Lithonia, Georgia technicians can calibrate and clear the system safely.

Yes. Modern thermostats communicate low-voltage signals (24VAC) to the furnace control board. Dead internal batteries, damaged wiring, loose C-wire connections, or faulty internal relays will prevent your furnace from receiving the heating call. Our technicians in Lithonia, Georgia test control circuit voltages and can re-wire or recalibrate your thermostat during the service call.