Furnace Repair Services in Paloma, CA

The draft inducer is a small motorized fan that turns on before the burners ignite. Its purpose is to pull combustion air through the heat exchanger and expel toxic exhaust gases safely out the flue vent. A pressure switch verifies that this draft is established; if the inducer motor fails or the vent is blocked, the furnace will lock out as a safety precaution.

During warm summer months, ambient dust settles onto the furnace burners and heat exchanger surfaces. During the first cold snap, this thin layer of dust burns off, producing a mild, transient burning odor that typically disappears within 30 to 45 minutes. If the smell persists, smells of burning plastic/wiring, or produces visible smoke, shut down the system and call (877) 719-1221 immediately.

Yes. Modern thermostats communicate low-voltage signals (24VAC) to the furnace control board. Dead internal batteries, damaged wiring, loose C-wire connections, or faulty internal relays will prevent your furnace from receiving the heating call. Our technicians in Paloma, California test control circuit voltages and can re-wire or recalibrate your thermostat during the service call.

Electric furnaces do not use combustible fuel or heat exchangers; instead, they pass high-voltage electric current through heavy-duty nichrome heating elements. Common electric furnace repairs involve replacing broken heating coils, stuck electric sequencers, faulty contactors, or blown thermal fuses. Our technicians in Paloma, California service both electric and gas heating configurations.

HVAC manufacturers and safety organizations recommend scheduling professional maintenance once per year, ideally in early autumn prior to continuous winter operation. Annual tune-ups clean combustion residues, verify gas pressure, inspect electrical connections, and verify safety controls, which prevents mid-winter breakdowns and lowers monthly utility bills in Paloma, California.

Cold air discharge usually points to an extinguished pilot flame, an oxidized flame sensor rod that shuts down the gas valve after a few seconds, an overheated heat exchanger tripping the high-limit switch, or an ignition lock-out. Our certified technicians in Paloma, California utilize digital multimeters and combustion testers to pinpoint the exact failure point and restore comfortable heat.